Avery Weigh-Tronix ZM305, User Instructions

Page: 51 / 58

ZM305 GTN Inbound-Outbound User Instructions 51
7.3 Truck
Lite menu
Truck  Edit  Lite
25. From Edit , press UNITS …
LitE is displayed. This item allows configuration of set point 1 & 2 to
control an external traffic light or device based on GTN operations.
26. Press SELECT …
EnAbLE is displayed. Choose from these three options under enable:
Manual BOTH the set point outputs #1 & #2 and the serial
commands for the XR4500TL are controlled by the
START / STOP keys.
Auto BOTH the set point outputs #1 & #2 and the serial
commands for the XR4500TL are controlled as follows:
• Set point #1 is active for green light when scale is
considered at ZERO while inside gross zero band, or
when the
PRINT key has been processed. (Scale
Configuration Parameter)
• Set point #2 is active for red light when gross weight is
above the threshold value.
• Set point #3 is available for standard configuration
(cutoff) as long as the battery saver feature is not used.
OFF Set point controls are controlled by standard configuration
settings (cutoffs) and ONLY the XR4500TL works with the
START / STOP keys.
27. From EnAbLE press the UNITS key …
t-HoLd is displayed. This stands for Threshold. Use this to configure the
weight value that must be exceeded for the light control to activate the
red light (set point #2) when configured for the AUTO mode of operation.
Outputs #1 and #2 must be enabled for the set point controls to function properly.
START key
The START key will update the XR4500 application print token (A65) to use
characters that control the green light control command on a XR4500TL remote
scoreboard equipped with the traffic light feature. The characters are included in the
default print format that is assigned to Broadcast to the remote scoreboard display.
STOP key
The STOP key will update the XR4500 application print token (A65) to use characters
that control the red light control command on a XR4500TL remote scoreboard
equipped with the traffic light feature. The characters “@ & <CR>” are included in the
default print format that is assigned to Broadcast to the remote scoreboard display.