35146AR
33
Sensor / Relay
Sensors
Enable
–
Enable or disable a sensor.
Sensor Number –
Sensor number associated with the ProConnect recorder.
Sensor Name
–
Name of the sensor associated with the ProConnect recorder.
Sensor Origin
–
Origin of the sensor being used by the ProConnect recorded (typically internal to the recorder).
Current State
–
Current state of the sensor (open or closed).
Default State
(NO/NC)
–
Normally Open or Normally Closed sensor.
Debounce
–
Debounce time in milliseconds (1000 milliseconds = 1 second) is the duration to ignore repeated
contacts
.
Associated Macros –
Shows any macros associated with a specific sensor.
Associated Camera
–
Allows the association of a specific camera to a sensor.
Image Offset
–
The delay between the start of a sensor event and the time an event is captured
Invert State –
Inverts the state of the sensor.
Setting Up A Sensor
1. Enable a specific sensor by checking the box in the
Enable
column.
2. Modify the ProConnect sensor number in the
Sensor Number
column if needed.
3. To modify the sensor name, type the new name into the
Sensor Name
box.
4. Set Normally Open or Normally Closed in the
Default State
(NO/NC) drop down.
5. Change
debounce
default in milliseconds if sensor contact is likely to break contact constantly.
6. Associate a camera to record with the sensor by selecting a camera from the
Associate Camera
drop
down.
7. Modify the image offset value if a delay is required when recording a sensor event.
8. Check the box labeled
Invert State
if desired.
9. Click
Save
.