avertX HDIP, User Manual

Page: 27 / 82

3222AF 27
The AvertX HDIP network video recorder uses IP network cameras. To
connect an IP camera, plug the network cable into the desired channel
on the back of the recorder. The HDIP has a built-in PoE switch, which
means that power is supplied to your camera over the network cable, so
there is no need to plug a separate power supply into your PoE-
equipped camera.
Note AvertX cameras use Power Over Ethernet (PoE), and will
work when plugged into your recorder without any other
equipment. If you are using IP cameras from another
manufacturer, you may need a separate power supply if it is
not a PoE camera.
Note The AvertX HDIP supports PTZ (Pan/Tilt/Zoom) cameras from
3
rd
Party ONVIF manufacturers.
Use the RJ45 jack on the rear of the recorder to connect to your router,
modem, or network switch. Do not use this port to connect to an IP
camera.
Connect wired alarm/sensor inputs to the Alarm In ports on the I/O
connector.
Connect wired relay outputs to the Alarm Out port on the I/O connector.