11
Step 7
Powering on EzRecorder 310
Press the power button on the front panel of the device.
Or
Aim the remote control at the infrared sensor located on the front panel of the device. Then press
POWER
on the remote.
The LED indicator then lights up green, indicating that the device is on.
Step 8
Check Video on TV Screen
Turn on your TV and make sure the screen is properly displayed.
If your TV is not displaying video properly, please check the followings:
Make sure that your TV is set on the correct input source (COMPONENT IN). Switch video input by pressing
the input selection button ("Input"/"Source"/"TV/AV") on the TV remote control.
Supported resolutions vary depending on the TV model in use. For details, please refer to the guide that
comes with your TV.
Check video output settings of your STB.
Power off EzRecorder 310 and then make sure that the device is connected properly and with the proper
cables.
If there is still no video signal on TV, refer to FAQ at www.avermedia.com for further troubleshooting.
