www.avenview.com
Page 7
4.
pANEl DESCRIpTION
4.1 INPUT PANEL (Transmitter, HBT-C6POE-S) Front
1.
HDMI IN: Connect
HDMI source Max 35ft
via HDMI Cable Blu-ray
player or Digital player
2.
lAN Connect to a router for lAN sharing. This allows network/internet
access) to be shared over the CATx to the RX.
Warning:
DO NOT
connect the lAN connection to the CAT5e/6/7 output,
this may trigger a power shut down and may damage the device.
3.
RS-232 IN: Connect to a device that has the ability to send control commands ( pC or laptop via D-Sub
9-pin male cable)
4.2 INPUT PANEL (Transmitter HBT-C6POE-S) Rear
4.
DC 24V: Connect the 24 V DC power supply in-
cluded. Secure screw connector.
5.
pOWER lED: This blue lED will illuminate when the
device is connected to a power supply.
6.
IR 1 Blaster: plug the IR Blaster cable for IR signal
being transmitted. place IR Blaster within direct site
of the device being controlled.
7.
IR 2 Extender: plug the IR Extender cable for IR signal
being received. place IR Extender within direct line of
site with the IR Remote.
8.
lINk lED: Illuminate when both the input and
output signals are in sync. The lED will blink inter-
mittently to indicate no signal is being received from
the display and irregularly to indicate that an error
has occurred.
9.
CAT5e/6/7 OuT: Connect CAT5e/6/7 cable to trans-
mit all data signals extend the signal to the Rx unit.
1
5
4
6
7
8
9
2
3
