Aventics PROFINET-IO, Operating Instructions Manual

Page: 86 / 348

Assembly
86 AVENTICS | PROFINET-IO | R412015162–BDL–001–AE
5.3.8 FE connection
O
To discharge EMC interferences, connect the FE
connection ( 2 ) on the left EP end plate of the VS via a low-
impedance line with a functional grounding.
Recommended cable cross-section: 10 mm
2
.
With an HF04-/HF04XF valve block, connect the FE connection ( 1 )
on the valve block to the functional grounding via a low-
impedance line.
5.4 PROFINET-IO fieldbus interface
The bus coupler can be operated on a PROFINET-IO fieldbus
with real-time classes RT and IRT.
2 1
4 3
PO WE R
X10
Table 15: Load supply assignment for 8x output module, 8DO, M12x1,
A-coded
Pin X10 Assignment
1 Free GND reference for power supply 2
2 0x 24 V supply voltage 1 for outputs O0 to O3
3 GND GND reference for power supply 1
4 24 V supply voltage 2 for outputs O4 to O7
2
NOTICE
Total current is too high
Every output is supplied with a continuous current of max. 0.5 A.
Current loads over 0.5 A per output can damage the system.
O
Make sure that the current load of 0.5 A per output is not
exceeded.
1
Type
Ethernet
Potential separation
Yes
Station address
Any in acc. with RFC specifications
Baud rate
100 MBaud