Avaya P333R, User Manual

Page: 41 / 270

Chapter 2 Avaya P333R Front and Rear Panels
Avaya P333R User’s Guide 21
Note:
To perform “Force Initial Version,” reset the module and at the same time
press the FIV reset button (use an opened paper clip or other pointed object). Let go
of the reset buttons first and then let go of the FIV button 1 or 2 seconds later.
Rx Receive from line
OFF – No receive activity
ON – Data received from the line into the
module
FDX Half/Full Duplex
OFF – Half duplex mode
ON – Full duplex mode
FC Flow Control
OFF – No flow control.
ON – Symmetric Flow Control mode is
enabled and port is in full duplex mode
Hspd High Speed 10/100 1000
OFF: 10 N/A
ON: 100 1000
Link Aggregation
Group (Trunking)
OFF – No LAG defined for this port
ON – Port belongs to a LAG
Table 2.2 Avaya P330 <- -> Select buttons
Description Function
Left/Right Individual – select LED function (see table above)
Reset module Press both right and left buttons together for approximately 2
seconds. All LEDs on module light up until buttons are
released.
Reset stack Press both Right and Left buttons together for 4 seconds. All
LEDs on stack light up until buttons are released.
FIV Force Initial Version – Boot from backup initial version of the
Avaya P330 software from Bank A (see Note below).
Table 2.1 Avaya P333R LED Descriptions (Continued)
LED Name Description LED Status