Installation procedure
Issue 4 October 2002
49
555-233-116
Figure 10.
Typical connections to a data module
Installation procedure
To install a typical data module, you perform the following tasks:
1.
Obtain required equipment
2.
Set hardware options
(must be completed before you administer or
physically connect the data module)
3.
Connect data modules
4.
Administer the data modules
(can be completed either before or after you
physically connect the data module)
1. 103A connector or modular wall jack
2. 400B2 adapter
3. Rear of data module (7400B Shown)
4. Host computer
5. Data module power supply
6. Electrical outlet
7. Display telephone
8. S101A speakerphone
9. Auxiliary power supply for telephone
10. D7AP cord
11. D8W cord
12. Line to display telephone (D8W cord)
13. Data cable (EIA/RS-232)
14. Data-module power cable
15. To MDF and system cabinet
16. Printer
Phone
Power
Port 1
Port 2
Line
cydfnst RPY 070397
Summary of Contents for MultiVantage
