Avaya MultiVantage, Installation Manual

Page: 223 / 246

Multimedia call handling (MMCH)
Issue 4 October 2002
223
555-233-116
9. Set the
Interface:
field to network
10. Set the
Country Protocol:field
to 1
11. Set the
Protocol Version:
field to a
12. Set the
CRC?:
field to y
13. The Idle Code default is 11111111.
14. The DCP/Analog Bearer Capability default is 3.1 kHz.
15. Set the
MMI Cabling Board:
field to xxxxx (where xxxxx is the
location of the TN787F/H/J/K MMI circuit pack recorded in step 2). This
must be the slot for port B of the Y-cable.
16.
The MMI Interface: field
ESM appears.
17. Enter add signaling-group next and the signaling-group form appears.
18. Change
Associated Signaling
: field to y
.
19. Change
Primary D-Channel Port
: field to xxxx17 (where xxxx is the
address of the TN2207 PRI circuit pack, for example: 1B0517).
20. The
Max Number of NCA TSC
: default is
0.
21. The
Max Number of GA TSC
: default is
0.
22.
Trunk Group for NCA TSC
: ____ (leave blank)
23.
Trunk Group for Channel Selection
:____ (leave blank)
24. Logoff the terminal and then log back on the terminal to view your changes.
Place test call
Place multimedia data-conference call to an endpoint with known video capability
to test the esm function.
Troubleshooting
To determine ESM link status enter the following commands from the system
administration terminal:
1. Status esm
2. Status signaling-group
3. List MMI
NOTE:
When you move ESM circuit packs, you MUST remove the DS1 and
signaling group translations. You cannot use the change circuit pack
command.
Refer to ‘‘Setup and test the MMCH installation’’ on page 214 for further
information.