Administering 4602 SIP Telephones
20 4602 SIP Telephone SIP Release 1.2 Administrator’s Guide
Upgrading on a Set-By-Set Basis
This procedure resets all the parameters H.323 code uses to their default values, including
resetting the SIG flag to the H.323 default value.
1. Use the administrator’s Web interface of the SIP phone you want to convert. Go to the
Network Settings page and make sure the Configuration HTTP Server IP Address is
properly set.
2. Go to the Firmware Update page. Specify the special conversion version of the H.323 boot
binary (sipto323XXXX.ebin) as the File to download.
3. Click Download Now to download the file.
The phone downloads the file. When completed, the message
Firmware upgrade
successful
displays.
4. Click Reset to reset the phone.
The phone restarts, looking to the TFTP server to download a script file. The messages
Starting
and
DHCP, press * for Setup
display.
Note:
Note:
If you are not using DHCP, you must manually configure the set. Use the local
ADDR
command to configure an IP address, subnet mask, gateway, and TFTP
server into the phone before proceeding.
5. Press * to enter the address configuration command.
The phone displays
phone=xxx.xxx.xxx.xxx, new=
.
6. Press * several times to scroll through the values without making changes. When the
message
no new values, #=OK
displays, press #.
The display goes blank.
7. Press Mute R E S E T # (Mute 73738 #).
8. Press # to reset all values, then press # again to restart the phone.
The script specifies a new boot and/or application file, which is then downloaded. After the
phone restarts, it runs using H.323.
Summary of Contents for IP Office 4602
Page 1: ...4602 SIP Telephone SIP Release 1 2 Administrator s Guide 16 300037 Issue 1 2 January 2005 ...
Page 2: ......
Page 12: ...About This Guide 12 4602 SIP Telephone SIP Release 1 2 Administrator s Guide ...
Page 48: ...Time Zone Determination 48 4602 SIP Telephone SIP Release 1 2 Administrator s Guide ...
