2-20
Chapter 2
Cajun P550R/P880/P882 Switch Installation Guide
7.
Enter the following command to copy the image from the
pcmcia file system on the flash card <filename1> to nvram on
the switch <filename2>:
cajun (configure)# copy pcmcia <filename1>
<filename2>
*Note:
Refer to the Cajun P550R/P880/P882 Switch
Command Line Reference guide, Chapter 26,
"System" for a detailed explanation of these and
other PCMCIA commands.
Downloading
the Software
Code onto a
Redundant CPU
* Note:
You must download the same version software code onto
both CPUs. The correct process for doing this is:
• Install the Primary CPU in slot 1
• Load the new software onto it from either the console
or the PCMCIA flash card
• Install the Redundant CPU in slot 2
• Load the new software onto it from either the console
or the PCMCIA flash card
To download new software code on a redundant CPU:
1. Connect
the Ethernet port on the
s
upervisor module in slot 2
to
the network (Figure 2-8).
2.
To download new software code onto a Redundant CPU:
—
Using the console, refer to the "Downloading the
Software Code on an Active CPU through the Console"
section earlier in this guide
—
Using the PCMCIA card on the front of the 80-Series
Subversion module, refer to "Downloading the Software
Code on an Active CPU through the PCMCIA" section
earlier in this guide.