Avaya C360 Manager, Installation And Configuration Manual

Page: 170 / 248

Avaya C360 Layer 3 Features
170 Installation and Configuration Guide Avaya C360 Multilayer Stackable Switches, version 4.5
Assigning Initial Router Parameters
To configure the initial router parameters perform the following via the CLI:
1. Type
set device-mode router
and press Enter.
You will be prompted to reset the switch.
2. Type y .
Wait for the switch to restart and for the CLI prompt to reappear.
3. Type
show device-mode
and press Enter to ensure that the module is in router mode.
Tip:
Tip:
Assign the stack IP address as described in Assigning C360 IP Stack Address on
page 66 before you assign the Initial Router IP address.
4. To access Router commands from the Master module, type the command
session
<module number> router
where
<module number>
is the location of the router
module in the stack, and press Enter.
The command prompt changes from
C360-N> to Router-N#>
where N is the number of
the router in the stack (see SNMP Support ).
5. Type
configure
and press Enter. The prompt
Router-N(configure)#
appears.
Specify the VLAN on which an
IP interface resides ip vlan/ip vlan name
Use this command before
configuring VLAN-oriented
parameters, when there is more
than one interface on the same
VLAN enable vlan commands
Display information about the IP
unicast routing table show ip route (Layer 3)
Display information for an IP
interface show ip interface
Display the status of ICMP error
messages show ip icmp
Delete a Layer 2 Router
interface clear vlan
In order to... Use the following command...
2 of 2