avantec DT910, User Manual, Page: 16 / 24

16
8.2 Register / Subscribe a New Handset (Multiple Handset
Scenario)
It is possible to subscribe additional handsets to the same base unit. A
maximum of 6 handsets can be supported by the system.
1.
Press and hold the page button on base station until the LED on
base station is flashing.
2. On the handset, in standby mode, press key to enter the
handset menu.
3. Press key until “ BS SETUP ” is displayed.
4. Press key, then press key until
“ REGISTER ” is displayed.
5. Press key, “ BASE 1 ” is displayed.
6. Press / key to select the base station
number that you want to register.
7. Press key, “ PIN? ” is displayed.
8. Enter the PIN code (The default PIN is “0000”).
9. Press key to validate the PIN and
start the registration process.
10. “Searching…” is displayed indicating that the handset is looking
for the selected base station.
(It may take up to 30 seconds for the handset to search for the
base.)
11. Upon successful registration, the handset will return to standby
screen and the assigned handset number will be shown “
HANDSET
1 ”.
Note:
If the handset does not locate the base unit, it will go back to standby
screen when times out. Please repeat the registration procedure and
make sure that the handset is placed closely to the base unit (approx..
10-20 cm).
If the handset emits a “double beep” during the registration, it means
that either the entered PIN is wrong or the base unit is full (already has 6
handsets registered).
A unique number is assigned to each handset (1-6) by the base unit
upon successful registration. This number is displayed on the handset as
“HANDSET X” during standby and the handset number is used for
making internal calls.