AVANT STAGEV 860i, Operator'S Manual

Page: 112 / 148

Service and maintenance Avant 860i
112
.
If you run out of fuel:
If you are running low on fuel and operate the loader
on tilted ground, the loader may stall as fuel flow to
the engine may be temporarily interrupted. Add fuel
to prevent stall on uneven surfaces.
After running out of fuel, the fuel system need to
primed:

There is a manual priming pump on the fuel filter,
which is accessible through a hole in the rear
cover. See picture below.

Press the manual priming pump repeatedly, until
it becomes stiff.
.
2. Check the general condition of the
loader

Check that all safety decals are in place and
legible.

Never operate loader if safety decals are
damaged or missing. Replace missing or
damaged safety decals before using the
loader.

Check the underside of the loader and ground
for leakages. Also check ground/floor surface for
signs of leakage.

Never operate the loader or its attachments,
if you have noticed a leak. Repair all leaks
before use.

Check the condition of the safety frame, seat
belt, lamps, and other safety equipment:

Safety frame (ROPS) and protective roof
(FOPS) must be fitted. Safety structures
must not have visible damage or
deformations. They must be replaced with
new ones after any incident.

Make sure all lighting devices and reflectors
are functional and clean

Check operation of reverse beeper (if
installed).

Check if the loader must be cleaned before
continuing with other daily maintenance
procedures in this chapter. Damaged parts or
other faults may not be visible if the loader is
dirty.

Check the metal parts for damages or rust.

Do not use the loader if you see damaged,
bent, corroded, or deformed metal parts.
Contact Avant service for service, if
necessary.

Check the condition of the loader after
cleaning of the loader. For more instructions
about inspecting the metal structures, bolts,
and fittings, see sections starting from page
116.