AVANT A424013, Operator'S Manual For Attachment

Page: 17 / 36

17 (36)
2. If your loader is

equipped with the Opticontrol
®,
or

the Attachment control switch pack, and the
loader is manufactured after 2016:
If the electric socket is integrated in the
multiconnector, the electric harness of the
attachment is connected when the multiconnector
is coupled. Clean both multiconnectors before
connecting the multiconnector.
The separate cable harness A34731 is not needed
in this case.
Opticontrol
®
, or Attachment control switch pack,
loader manufactured in 2016 or later
3. If your loader is

equipped with the Attachment control switch
pack, and the loader is manufactured before
2016:
If there is an electric socket near the
multiconnector of the loader, disconnect the
electric plug from the multiconnector and connect it
to the electric plug of the loader.
The separate cable harness A34731 is not needed
in this case.
Attachment control switch pack, loader
manufactured in 2015 or before
Make sure that electric cables will not get stuck, squeezed, or stretched when the
equipment moves.
With the help of the attachment control switch pack available for the loader, the
attachment control switches are easily accessible at the end of the boom control lever.
More information about the power outlet of the loader can be found in the operator’s
manual of the loader.