AVANT A424013, Operator'S Manual For Attachment

Page: 27 / 36

27 (36)
Check the routing of hoses and movements of the attachment
After tightening the hydraulic components, test the movements of the attachment thoroughly. Check that the
hydraulic hoses cannot get stretched or pinched in any position of the loader boom or the attachment, and
check that the hoses are not in contact with sharp edges.
6.6.3 Installation
The mechanical side hatch brackets (1) are replaced with hydraulic cylinders (2).
1
Undo the screws (4) and locking pins (5) and
remove both mechanical side hatch brackets (1).
2 Install the hydraulic cylinder (2) on both sides of
the attachment. Fix the cylinder with screws (4)
and locking pin (5).
3 Install the control valve (3). Fix the valve with
screws (6).