AVANT A36883, Operator'S Manual For Attachment

Page: 8 / 40

8 (40)
WARNING

Make sure to use only an attachment that is in good condition. Check the attachment
thoroughly in regular intervals. Do not modify the attachment in a manner that would
affect its safety. It is prohibited to drill holes on the attachment, and welding or other
means of fixing hooks or other objects on the attachment is strictly prohibited.

Use the attachment only for its intended purpose. Other use may create unnecessary
safety risks, and the equipment may get damaged.

Make sure that the loader is equipped with necessary safety components, and that
they are in working condition. Seat belt must be used. If there are specific hazards
related to the operating area, use appropriate safety equipment.

Also read the safety instructions and correct use of the loader from the operator's
manual of the loader.
WARNING
Hazard of thrown objects - Keep bystanders away. Note
that the attachment can throw stones, gravel, or other objects
found in the area at high speed. Always keep a safety
distance of at least 2 metres to other persons.
WARNING
Risk of tipping over - Avoid overload.
Loader can tip over
when handling too heavy loads, or because of dynamic
movements caused by driving with and handling of a heavy
load. Do not extend the telescopic boom when the load
approaches the lifting capacity of the loader, or when the
loader boom is in horizontal position. When you notice that
the rear wheels of the loader are about to lift from the ground,
or if the load indicator of the loader (if fitted) signals:

Lower the load calmly and retract the telescopic boom

Avoid sudden changes in speed or direction whenever load is lifted

Use additional counterweights as needed
. ..
WARNING
Entanglement hazard - do not use loose clothing during operation. Never wear
loose clothing, long scarves, jewellery, or other items that might become entangled with
rotating parts while operating the attachment. If needed, wear a hat to prevent long hair
from coming into contact with the rotating parts.