Page
13
of
54
Pole Mount
For a pole mount installation, the AV-WMJB-W wall mount, AV-PMA-W pole mount, and SO-CAP-W
mount cap are required (sold separately). A pole mount should only be attached onto hard ceilings
including wood, plastic, metal, and concrete.
1.
Using the mounting template, prepare the mounting provisions for the camera installation.
2.
Connect the wall mount cap and wall mount.
3.
Attach the AV-JBA-W (Junction Box Adapter) to the Pole Mount Adapter (Figure 1).
4.
Remove the conduit plug on the junction box adapter and connect ¾” NPT conduit to the junction
box adapter (Figure 1).
Figure 1: Attach conduit to AV-JBA-W junction box adapter
Reference #
Description
1
Remove conduit plug
2
Connect ¾” NPT conduit to junction box adapter (ensure use of water seal tape)
NOTE: Use silicon or water pipe seal tape to make sure no water leakage between conduit pipe
and junction box adapter.
5.
Run the Ethernet cable and outside power cable (if necessary) through the supplied rubber
gasket and then through the Junction Box Adapter and AV-WMJB-W, Wall Mount Adapter.
Ensure the gasket is seated properly.
6.
Attach the Wall Mount Adapter (AV-WMJB-W) with mount cap (SO-CAP-W) to the Pole Mount
Adapter (AV-PMA-W) as shown in Figure 2.