© 2018 Autoslide Pty Ltd
MultiDrive
26
Figure 35: The top bracket position.
3.
Bolt the belt clamp to the top loop of the belt (Figure 36).
Figure 36: Bolt the top bracket onto the top loop of the belt.
4.
Mark the three bracket holes on the door (Figure 35) then drill
0.24” (6 mm) holes in the door at those positions.
Note
: Keep the holes above the glass in the sliding door to
avoid damaging the glass. If necessary, you can push the belt
up
0.1” (a few millimeters) to avoid the glass.
5.
Hold the top bracket against the door. Pack out any gap with
spacers
(each have a thickness of 0.04” or 1 mm). The belt
should run parallel with the door. The bracket
must not bend
the belt sideways
.
6.
Screw the top bracket (and any spacers) to the door.
(i)
Cover
Clip the cover over the base to cover the MultiDrive mechanism
(Figure 37).
Note:
–
Make sure the end of the cover clips sits in the track at the
edge of the cover.
–
If a cover clip does not fit into the track, use a screwdriver
to slightly expand the track until the clip fits.
E
A
C
D
B
F
G
H
DETAIL
A
SCALE
1 : 1
DETAIL
B
SCALE
1 : 1
DETAIL
C
SCALE
1 : 1
DETAIL
D
SCALE
1 : 1
DETAIL
E
SCALE
1 : 1
DETAIL
F
SCALE
1 : 1
DETAIL
G
SCALE
1 : 1
DETAIL
H
SCALE
1 : 1
DETAIL
E
SCA
LE
1 :
1
DETAIL
F
SCA
LE
1 :
1
DETAIL
G
SCA
LE
1 :
1
DETAIL
H
SCA
LE
1 :
1
E
A
C
D
B
F
G
H
DETAIL
A
SCALE
1 : 1
DETAIL
B
SCALE
1 : 1
DETAIL
C
SCALE
1 : 1
DETAIL
D
SCALE
1 : 1
DETAIL
E
SCALE
1 : 1
DETAIL
F
SCALE
1 : 1
DETAIL
G
SCALE
1 : 1
DETAIL
H
SCALE
1 : 1