© 2018 Autoslide Pty Ltd
MultiDrive
24
If
H
≥ 0.99” (25 mm):
If
H
is 0.99
” (25 mm) or more, screw the base to the
vertical
surface below the transom (Figure 32), as described below.
Figure 32: If
H
≥ 0.99” (25 mm), screw the base to the vertical surface
below the transom.
1.
As shown in Figure 33, drill holes for
0.24” (6 mm) screws into
the base in seven places:
–
at both ends of the motor, no more than
0.8” (20 mm)
away
–
at both ends of the belt tensioner, no more than
0.8”
(20 mm) away
–
near each end cap
–
in the middle of the base.
Figure 33: Screw positions in the base if
H
≥ .99” (25 mm).
2.
Put the base into position under the transom so that:
–
H
is
less
than 0.99
” (25 mm), and
–
the holes in the base are
clear of the sliding doors
.
3.
Using the
0.24” (6 mm) holes in the base as a drill guide, drill
0.24” (6 mm) holes into the vertical surface behind the base.
You may need to clamp the base in position while doing this.
4.
Use seven screws to hold the base in place.
5.
If the belt sags, increase the belt tension as described above.
4. Attach the brackets and cover
(a)
Bottom bracket
For bi-parting doors:
1.
Open
the doors fully.
