© 2018 Autoslide Pty Ltd
MultiDrive
12
2. Attach Parts to the Base Prior to Mounting
The base holds the belt tensioner, motor, controller, AC adapter,
cover clips, Wi-Fi Module, and back up battery (option accessory).
It is important to place these parts in the correct positions
described below.
(a)
Preparation
The layout of parts depends on whether the door is bi-parting, right
handed, or left handed.
Figure 7: Bi-parting doors: motor (1) is on the left.
Figure 8: Right handed door: motor (1) is on the left.
Figure 9: Left handed door: motor (1) is on the right.
Steps
1.
Lay the base on the floor directly in front of the door frame.
Align the center of the base with the center of the door frame.
2.
Each part attaches to the base
with one or two “sliders”
(Figure 10), which fit into the tracks on the base.
Remove the
nuts from all sliders
.
3.
If you are installing optional wired sensors, lay the sensor
cable(s) on the base between the two tracks. The sensor
cable(s) will pass
underneath
the cover clips and motor.
1
1
1
