Autoslide Elite, Installation Manual

Page: 19 / 36

DIP SWITCH SETTINGS GUIDE
Eight white DIP switches are located at the bottom of the control panel:
1
Direction/Learn


Leave in OFF position for right-handed door
operation. Leave in ON position for left-
handed door operation.
Toggling
this back & forth in Blue Mode will
program the stacker opening width.

Toggling
this back & forth in
green or red
mode program
s
the human opening width.
2
Slam Shut

Boosts power at the start of the opening
and end of the closing of the door
when
in ON position
.

Designed for tight jambs
and
weatherseals
.

Can’t be used when DIP #7 is
ON
.
3
Pet Learn

This switch is used to program the pet width
of the AutoSlide.

Toggle ON
and
OFF to start and stop
the
door at the desired pet open width.

The direction (left-opening vs right-opening)
is already determined from DIP #1.
4
Secure Pet

This switch is used to disable the Outside
Sensor
channel
in Pet Mode.

Designed for security-based pet setups
with iLock units.
5
75% Power

Reduces the power of the motor if the unit
opens too fast or if the door is too light
in
weight.

Usually turned
ON
when automating
lightweight screen doors
or pocket doors.
6
App Control

When turned
OFF
, enables
manual
motherboard control of the system.

When turned
ON
, enables
Bluetooth
Module (app) control of the system.

This should only be on if an
Bluetooth
module is plugged in and installed.
7
Extra Power

Increases the amount of power the motor
uses for heavier sliding doors.

Turn
ON
if motor is struggling to open/
c
lose
door.

This cannot be used when DIP #2 is
ON
.
8
Beep

When turned
ON,
the AutoSlide will emit
an audible beep when the door opens
,
starts to close, and when it changes
modes.
OFF
position is towards the
front of the control panel
ON
position is towards
the back of the control
panel