21
hh
PROGRAMMING FULL OPENING WIDTH
3)
Ensure an open jamb/doorstopper is in
place in the desired max opening
position, so the door doesn’t run off
the Auto
S
lide track.
To start the programming process,
reverse DIP switch #1 from its current
position
,
then
immediately
reverse back
DIP switch #1 (flip it back and forth).
- The door will immediately open until it
hits an open jamb or doorstop.
If none
exist, manually brace the door when it
reaches the desired opening width to
keep it from opening any further.
Once the programming process
has
started, the door will:
1. Slow
open fully
2. Slow
close fully
3. Fast
open partially
4. Slow
close fully
Once the door
remains
in the fully closed
position with a solid Green
M
ode light, the
full opening width is programmed.
To test the door, press the button for Inside
Sensor located at the top right of the control
panel. The door should open and close
automatically (if the Open
Time dial isn’t
set
at
the
max
position
).
Summary of Contents for Elite
Page 3: ...CONTENT ...