autoright C900145, Manual

Page: 7 / 16

ENGLISH 7
BUFFING
1. Pad is attached using hook and loop.
( Figure 1)
2. Pull the trigger and apply an even layer of
wax or polish using long strokes. Move the
polisher from front to back and side to side
as shown in Figure 2.
3. Remove the wax or polish in the same
order as it was applied, starting with a fresh,
clean pad.
4. DO NOT press down. Let the polisher
do the work. If the wax seems difficult
to polish, you may have applied too
much wax.
VARIABLE SPEED TRIGGER
This polisher comes with a variable speed
trigger which allows you to control the speed
of the unit to achieve your desired polishing
finish. The deeper you pull the trigger, the
faster the polisher spins until it is up to full rpm.
The polisher also allows you to dial in six
specific speeds and lock them in place. The
variable control knob adjusts from low speed
(A) up to high speed (F). ( Figure 3)
Once you adjust the control knob to your
preferred setting, pull the trigger and press the
trigger locking button on the side of the unit to
hold that speed. (
Figure 4)
To disengage the locked trigger, simply pull
and release the trigger again and it will turn off.
Figure 1
Figure 2
Figure 3
Figure 4
7
OPERATING INSTRUCTIONS