Autoquip PLTC-58120, Installation, Operation And Service Manual

Page: 16 / 56

16
Prevent serious injury or death.
Electrical service installation must be performed by a licensed
electrician and conform to all local and national electrical codes.
4.3 Pit Installation
Do not install lift in a pit unless lift has a bevel toe guard or other
approved toe protection. A shear point may exist which can cause
severe foot injury.
Lift platforms traveling below floor levels may create a toe hazard as load
passes top edge of pit. This may require guarding in accordance with
ANSI MH29.1. Guarding must be installed prior to operating lift.
1. Check pit dimensions (Reference drawing 82600431 below). Pit should be 2" longer and
2” wider than
lift platform
to allow a 1” gap between platform and pit. Pit depth should allow ½” for shims or grout.
2. Conduit diameter must be a minimum of 3" with long radius sweeps for necessary hydraulic hosing
and field wiring.
3. Verify installation area is clean before starting. Check mounting surface of pit floor with a level or
straight edge. If floor is not level, add shims or grout under entire perimeter of base to achieve a level
and flat base installation. A level base is essential for proper wheel tracking and smooth lift operation.
Prevent serious injury or death.
Depending on model, standard weight of lift ranges from 500
– 4700 lbs.
Use a properly rated lifting device to move and install lift.
i WARNING
i WARNING
i WARNING