3
INSTALLER WARNINGS
This Remote Starter with Keyless Entry System is designed to be
installed on fuel injected vehicles with an automatic transmission ONLY.
n
Never install this remote starter on a manual transmission vehicle.
n
This system must be installed and wired through a safety switch it will
not start in any forward or reverse gear.
n
Some automatic transmission vehicles [mainly older GM vehicles
with a purple starter wire] have a mechanical-type park safety switch
instead of electrical safety switch. The mechanical type does not
interrupt the starter circuit when the transmission is any gear and does
not offer the 100% level of safety required for remote starting purposes.
Therefore, our system should never be installed on any vehicle that
uses a mechanical type park safety switch.
n
After you have installed this system, you must verify that the vehicle
will not start any forward or reverse gear, regardless of the type of
vehicle.
n
Please read the operation manual for operating instructions
n
Do not install any component near the brake, gas pedal or steering
linkage.
n
Some vehicles have a factory installed transponder immobilizer
system that can severely complicate the installation. There is possibility
that this system can not be installed on some immobilizer equipped
vehicles.
n
Most vehicles have an SRS air bag system. Use extreme care and
do not probe any wires of the SRS system.
n
Disconnect the car battery before beginning work on the vehicle.
n
Check behind panels before drilling any holes. Ensure that no wiring
harness or other components are located behind the panels that would
otherwise be damaged.
n
Use of conventional crimp locks, bullet on any wiring. Poor wiring, i.e.
taped joints will possibly introduce unreliability into the alarm system and
may result in false alarms or incorrect operation. We suggest soldering
all connection points.
n
Install the wiring neatly under carpets or behind trim to prevent
possible damage to wires.
