23
RPM LEARNING:
While the system is in Start Feature
“D”
programming mode,
1. Press and release the transmitter
button once, [1] LED flash, [1]
horn chirp indicating you are in features “RPM Learning mode”.
2. Start the vehicle with the key. (While the engine is running, the parking
light & LED will flash, if not, please check the tachometer
White/Red wire connection.
3. Press and hold the valet switch for 2 seconds until a long chirp and the
LED light is constant for two seconds. The RPM signal is learned.
4. Once you complete step 3, you can adjust and test “Check Level” as
below:
CHECK LEVEL PROGRAMMING: (TEST & ADJUST)
While the system is in Start Feature
“D”
programming mode,
1. Press the
button on the transmitter to start the vehicle.
2. If everything goes well:
a. Press the
button on the transmitter to stop engine running. You
have been completed this programming successfully.
b. Press
button on the transmitter to exit the program mode. There
will be 3 long chirps & 3 parking light flashes for confirmation.
3. If the crank time is too long, (starter will crank while the engine is
running):
a. Press the
button
on the transmitter to stop engine running.
Press
button on the transmitter to set proper “Check Level ” to
Low position. [1] LED flash,
[1] horn chirp to confirm this setting
b. Repeat the step1 – 4.
4. If the crank time is too short, (Engine not running, after starter stops
cranking):
a. Press the
button on the transmitter to stop engine running.
Press
button on the transmitter to set proper “ Check Level ” to
Hi position. [2] LED flash,
[2] horn chirp to confirm this setting
b. Repeat the step1 – 4.
