13
FACTORY SECURITY DISARM SIGNAL OUTPUT –
(See Alarm Feature A- 3 Programming)
This wire is designed to disarm a factory installed security system. This
wire sends a negative (-) 1 seconds pulse upon a remote start and
remote door unlocking. Some factory systems must be disarmed to
allow remote starting. In most cases, this wire may be connected
directly to the factory alarm disarm wire.
SENSOR BY-PASS
OUTPUT–
(See Alarm Feature A - 3 Programming)
This wire is used for a by-pass module. This wire will supply an output
at all times the remote start is operating plus an additional 3 seconds
after the remote start unit turn off.
In some cases a vehicle may require a timed pulsed output
or key sense wire. If needed program the Sensor by-pass
20 seconds.
GRAY WIRE – (-) 200ma PROGRAMMING OUTPUT
(See Feature A - 2 Programming)
CHANNEL 2 Output (Factory Default Setting)–
This will become a 1 second pulse ground by activate channel 2 on
transmitter for two seconds, the current capacity of this wire is 200 mA.
This feature allows you to remote control trunk release or other electric
device.
87a
86
87
30
85
Fuse
Gray Wire
+12V Or Ground
Depending On System
Requirements
+12V
Electric Device
CHANNEL 2
FACTORY SECURITY REARM SIGNAL OUTPUT–
(See Alarm Feature A - 2 Programming)
This wire is designed to rearm a factory installed security system. This
wire will supply a pulse whenever the remote start times out or is shut
down using the transmitter and remote door locking..
WHITE/BLUE WIRE – (-) INSTANT START & TURN OFF INPUT –
This wires activates and turns off the remote starter each time it sees a
momentary ground signal. Use to integrate with a factory or after-market
system. 1-pulse is for an Aftermarket alarm and 3-pulse is for Factory
systems.
See Alarm Feature B-4 programming.
