Automation Direct D0-DEVNETS, User Manual

Page: 15 / 78

Installation and
Safety Guidelines
Installing the DeviceNet
Slave Module
2–4
Installing the D0–DEVNETS Slave Module
D0–DEVNETS DeviceNet Slave
Module User Manual, Rev A
When the D0–DEVNETS module is ready to be installed the protective option slot
cover must be removed. The protective cover is removed from the option card slot by
squeezing the pinch tabs and lifting the cover off.
Option Module
Slot Covers
Pinch Tabs
C0 C4 C2 X1 X3 X4 X6 X11 X13 X14 X16 X21 X23 N.C.
C1 C3 X2 X5 X7 X10 X12 X15 X17 X20 X22 X0 N.C.
AC(N) 24V
0V
N.C.
C1 C3 Y0 Y15 Y12 Y10 Y17 Y7 Y5 Y2
C0 C2 Y16 Y14 Y13 Y11 Y6 Y4 Y3 Y1
LG G
AC(L)
2.0A OUTPUT: 6–240V 50 – 60Hz 2.0A, 6 – 27V
INPUT: 12 – 24V 3 – 15mA
Y
X
40VA 50–60Hz PWR: 100–240V
0 1 2 3 4 5 6 7 10 11 12 13 14 15 16 17 20 21 22 23
PORT1 PORT2
TERM
RUN STOP
PWR
RUN
CPU
TX1
RX1
TX2
RX2
D0–06DR
WARNING: Power to the PLC must be disconnected before inserting or removing
the D0–DEVNETS slave module. Failure to disconnect power could result in serious
damage to the module, the PLC or both.
Remove the
Slot Cover