Owner Installation Instructions
Dual Gate Controller DCB-05
11
Initial electrical installation
CAUTION: Cables which have a green/yellow
coloured insulation are for earthing purposes
only. Never use these cables for any other
purpose.
Step 1. Wiring motors and limit switches
The Dual Gate Controller can be connected to the gate
drive units in one of several ways. The diagrams
(Fig.
2 to Fig. 4)
show the various wiring methods used
for different drive unit types. Select the appropriate
method for your drive unit.
Note “non-motor current carrying limit-switch” type
drive units can be connected using the standard 5 wire
connections or a special 3 wire method that uses a
single limit switch sense wire and two diodes.
If two drive units are used, repeat the wiring for the
second motor using the MOTOR 2 terminals.
Note the drive unit connected to the MOTOR 1
terminals will open fi rst and will be used for pedestrian
access.
The motor travel direction can be reversed by swapping
the motor connections. An opportunity to confi rm the
correct motor polarity is provided during the limit setup
procedure.
Step 2. Installing antenna
Mount the antenna at or above the height of the gate or
fence (whichever is higher) for optimal reception. Do not
cut the coaxial cable.
02
fi g
MI
Close
MOTOR 2 CONNECTOR 1
MOTOR 2 CONNECTOR 2
MOTOR 2 CLOSE LIMIT SWITCH INPUT
MOTOR 2 OPEN LIMIT SWITCH INPUT
COMMON FOR MOTOR 1 & 2 LIMIT SWITCHS
MOTOR 1 CLOSE LIMIT SWITCH INPUT
MOTOR 1 OPEN LIMIT SWITCH INPUT
MOTOR 1 CONNECTOR 1
MOTOR 1 CONNECTOR 2
24 VOLTS DC OUTPUT PLUS (+)
24 VOLTS DC OUTPUT MINUS (-)
Open
MOTOR 1
03
fi g
MI
1N4004 diode
open
close
1N4004 diode
MOTOR 1
MOTOR 2 CONNECTOR 1
MOTOR 2 CONNECTOR 2
MOTOR 2 CLOSE LIMIT SWITCH INPUT
MOTOR 2 OPEN LIMIT SWITCH INPUT
COMMON FOR MOTOR 1 & 2 LIMIT SWITCHS
MOTOR 1 CLOSE LIMIT SWITCH INPUT
MOTOR 1 OPEN LIMIT SWITCH INPUT
MOTOR 1 CONNECTOR 1
MOTOR 1 CONNECTOR 2
24 VOLTS DC OUTPUT PLUS (+)
24 VOLTS DC OUTPUT MINUS (-)
MI
MOTOR 2 CONNECTOR 1
MOTOR 2 CONNECTOR 2
MOTOR 2 CLOSE LIMIT SWITCH INPUT
MOTOR 2 OPEN LIMIT SWITCH INPUT
COMMON FOR MOTOR 1 & 2 LIMIT SWITCHS
MOTOR 1 CLOSE LIMIT SWITCH INPUT
MOTOR 1 OPEN LIMIT SWITCH INPUT
MOTOR 1 CONNECTOR 1
MOTOR 1 CONNECTOR 2
24 VOLTS DC OUTPUT PLUS (+)
24 VOLTS DC OUTPUT MINUS (-)
MOTOR 1
04
fi g
