INSTRUCTIONS MAGRO-35A
Page 14
SWING GATE OPENER
C3
Time of auto close.
0-99s
0
if you choose "0", the gate system will not have
auto closing function.
If you choose "10", it means the gates will
automatically close 10 seconds after completing
its opening.
C4
Time delay for opening, and delay for closing.
During opening, motor B will open a little later
than motor A During closing, motor A will close
a little later than motor B
0.1~99s
2
C5
Delay activating time for remote control button
(for avoiding mis operation)
If choose " 0 ", normal operation
If choose " 1 ", delay 2 seconds then start the
operation
If choose "2", first press stop button for 2
seconds, then close /open button to activate the
operation
0
0~2
C8
Battery capacity display
Below 30 = battery soon will be run out
99 = fully charged
0~99
C9
Reversed terminal for maintenance and
testing
D0
PCB Model Number
Display PCB Model &
Software version Number
D1
PCB Software Version
D2
Restore default setting
“09” = restore factory settings
0
C8
Self-learning feature
Press & hold “Enter”
button to turn to self-
learning mode
*Use this guide to help trouble shoot gates that are not operating properly. You can also
set some of the auto open functions and delay functions using this guide.
1. For most of these functions, it’s only necessary to adjust them if the system is not
opening or closing as desired.
2. Default settings can be reset directly from the power control box.
3. Please note that the gates open and close in the following manner: slow start,
fast swing and slow finish . To adjust each of these speeds, refer to the chart above.
