INSTRUCTIONS MAGRO-35A
Page 15
SWING GATE OPENER
Battery Wiring Instructions
1. Using the wire, connect the connector to the po) terminal of one of the batteries.
Connect the other end of the wire to the negative (_) terminal of the OTHER BATTERY.
2. Using the other wire, connect the connector to the positive (+) terminal of the battery.
After the batteries are installed, the other end will be connected to the control board.
3. Using another wire, connect it to the negative (-) terminal of the battery. After the
batteries are installed, the other end will be connected to the Control board.
Note: make sure the bare ends of the wires do not touch together or do not
touch the same metal surface at the same time.
4. Connect the other end of the wire that is already connected to the positive te) of
the battery to the positive (+) terminal in the control board for the battery.
5. Connect the other end of the wire that is already connected to the negative (-) terminal
of the battery to the negative (-) terminal in the control board for the battery
(terminal-12).
Battery Maintenance
Before use the batteries, please make sure that they are fully charged, it will lead to wrong
operation if it is not fully charged, and need to check or replace the batteries by qualified
person on a regular time basis.
*Recommend to use 2pcs of 12v 9Ah battery connection in series
Flashing light installation
Proprietary Intellectual Property. Do not Distribute without authorization.
All Rights Reserved-Copyright@2015 Autoglide
www.autoglideglobal.com
