9-2
FITTED EQUIPMENT
To light the grill, push in the control knob and
turn 90 degrees anti-clockwise to full rate.
Hold a lighted match or taper to the burner
and push the control knob in and hold. It is
necessary to hold the knob depressed after
the burner has ignited for approximately 10-
15 seconds, to allow the thermocouple probe
to reach temperature, before releasing the
knob. Should the flame go out when the knob
is released, the procedure should be
repeated holding the knob depressed for
slightly longer.
For models fitted with spark ignition the
procedure is similar except that the burner
can be ignited by depressing the ignition
button, which is located on the fascia. If the
burner has not lit within 15 seconds the
control knob should be released and the
burner left for at least one minute before a
further attempt to ignite the burner.
For simmering, turn the knob further anti-
clockwise to the low rate position.
To turn off: Turn the control knob until the line
on the control knob is aligned with the dot on
the control panel. Always make sure the
control knob is in the off position when you
have finished using the hotplate burners.
IMPORTANT:
•
The pan supplied with the appliance is
multi functional, for use in grill or oven.
•
The handle design allows removal or
insertion whilst the pan is in use.
•
Always remove the handle when the pan
is in use.
THE GRILL
The door must be open when the grill is
used.
Cautions:
(1) When the grill is being used, accessible
parts may be hot, young children must be
kept away.
(2) Never cover the grill pan or trivet with
cooking foil, or allow fat to build up in the
grill pan as this causes a fire hazard.
(3) Keep all flammable material away from
the appliance.
To light the grill, push in the control knob and
turn 90 degrees anti-clockwise to full rate.
Hold a lighted match or taper to the burner
and push the control knob in and hold. The
burner should ignite and the control knob
should be held in for 10-15 seconds before
release. If the burner goes out, repeat
procedure holding control knob for slightly
longer.
For models fitted with spark ignition the
procedure is similar except that the burner
can be ignited by depressing the ignition
button, which is located on the fascia. Ignition
must be carried out with the door open, and if
the burner has not lit within 15 seconds the
control knob should be released and the grill
left for at least one minute before a further
attempt to ignite the burner.
On first use of the grill, it should be heated for
about 20 minutes to eliminate any residual
factory lubricants that might impart
unpleasant smells to the food being cooked.
A non-toxic smoke may occur when using for
the first time so open any windows and turn
on mechanical ventilators to help remove the
smoke.
Summary of Contents for warwick duo 2008
