9-18
FITTED EQUIPMENT
come on. This delay is built in to avoid
switching to gas operation, and igniting
the burner, whenever you stop to refuel
the vehicle. If the system selects gas
operation, the ignition will be activated
automatically. The gas will flow to the
burner and be lit by the electric ignition. If
the flame goes out, the gas will
immediately be lit again.
•
Manual selection:
Note: If the flame
cannot be lit within 30 seconds, the gas
supply will stop and gas mode will be
switched off, the LED start flashing and
an error code shown on the LCD display.
The gas mode can be reset only if the
refrigerator is switched off. If you switch
the refrigerator on again and the gas
mode is still not working, the LED of the
manual gas mode will flash to indicate
that gas is unavailable and an error code
is shown in the LCD display.
Important Note:
•
It is prohibited to use gas to power the
refrigerator while you are driving. If a
road accident results in a fire, there is
danger of an explosion.
•
It is prohibited to use gas to power the
refrigerator in the vicinity of petrol
stations. If it will take longer than
15minutes to refuel your vehicle you
should switch the refrigerator off using
the main switch (A).
Switching off
•
Push the main switch (A)
•
The blue LED will go out
•
The refrigerator is now completely
switched off.
•
Use the special door latch on the door
locking mechanism to hold the door
open, in order to prevent unpleasant
odours and mould in the refrigerator.
Maintenance
Regular maintenance is necessary to ensure
the correct functioning of your refrigerator.
Cleaning
•
Clean the refrigerator with a soft cloth
and mild detergent
•
Dust the refrigerator with a soft
moistened cloth
•
Do not use soap or aggressive
detergents that are abrasive or soda-
based.
•
Note the removable interior components
of the refrigerator are not dishwasher
proof.
Defrosting
•
The refrigerator should defrost itself
automatically. However, should it be
necessary to manually defrost the
refrigerator observe the following:
•
Act once the frost layer reaches about
3mm thick.
•
Remove contents of refrigerator and
switch off.
•
Leave the door open.
•
Place dry towels inside to absorb the
water.
•
Place trays of hot water in the freezer
compartment.
•
After defrosting use a cloth to dry the
inside
•
Switch on again
Important:
Do not use force or sharp objects
to remove frost. Do not try to accelerate
defrosting by using (for example) a hairdryer.
Door locking mechanism
Frost will form in the refrigerator if the door is
not closed properly. To check this, close the
door with a piece of paper between the door
and the refrigerator. Pull at the piece of
paper. If you feel resistance, the door closes
properly. If you feel no resistance, the door
does not close properly. Perform this test
regularly on all sides of the door. If you find
that the door does not close properly, check
whether the door locking mechanism keeps
the door properly shut.
Summary of Contents for Peugeot Kemerton
