Auto-Sleepers Broadway FB, Handbook

Page: 47 / 130

7-23
CONNECTION OF SERVICES
3.11 System Warnings
The system incorporates a number of warnings that are active at specific times. These are
summarised below, and also covered by relevant sections of this manual.
Warning When Type
Fresh water level low With pump turned on and fresh water Message on screen and 1 minute
level low (less than 25% full) audible beep
Waste water level full With pump turned on and waste water Message on screen and 1 minute
level full (tank level 100%) audible beep
Vehicle battery voltage With control panel power on and vehicle Message on screen and 1 minute
low battery selected (as active battery) and audible beep. If no action taken after
voltage level below 10.9V 1 minute then the system will switch to
the leisure battery
Leisure battery voltage With control panel power on and leisure Message on screen and 1 minute
low battery selected (as active battery) and audible beep. If no action taken after
voltage level below 9V 1 minute then the system will switch
the power of to prevent over discharge
of the battery
Alarm clock active When alarm has been turned on and Message on screen and 1 minute
alarm time has been reached audible beep
Engine running When the engine is started the system Message on screen, on EC480 this
power will be turned off will remain visible for 1 minute
Step still out When the engine is started and the step Message on screen and rapid beeps
has failed to retract automatically from the control panel. The beeping
will not stop until the fault is cleared.
Mains lead (hook-up When the engine is started and the Message on screen and repeated
cable) still connected / mains cable is still plugged in and beeps from the control panel. The
plugged in switched on beeping will not stop until the fault is
cleared.
3.12 Event Timer Operation
The event timer is designed to allow the motorhome user to turn the 12v power on or off (in the
same way as using the control panel power button) without being in the vehicle. This allows
lights or other equipment to be turned on or off at a predetermined time.
Example - to turn on one interior light at 11.00pm for 1 hour
Ensure the clock is set to the correct time
EC480
Scroll to the System Time Setting screen
Follow the instructions in section 4 to set the ON time to 23:00 and the OFF time to 24:00
Set the Timer to ON
A stopwatch symbol will appear in the header area to indicate the timer is set
Turn all lights and 12v equipment off in the vehicle except the light that you want the event
timer to automatically switch on
Exit the vehicle At 11:00pm (23:00) the control panel will switch the 12v power on and
therefore any equipment that was left switched on will be turned on. The 12v power will be
switched off at Midnight (24:00).