20
9
1
HOOK UP
Press the On/Off button: Connect the clamps as instructed on the LCD.
Enter the approximate battery
temperature in degrees Fahrenheit then press (Y Enter).
Note:
Go to the setup to change temp scale to centigrade. The temperature
request only appears once for each battery tested. If the clamps are
disconnected you will be prompted again to begin a new battery test.
Note!
Take special care when connecting to battery side terminals. If
necessary use a side post adapter to prevent thread damage. When
testing dual post batteries always check the post to which the system is
attached. If a load test is made from a post connection and the alternator
is mounted to side terminals a battery load test can be completed, but
a continuity problem may still be in the side terminals when testing the
alternator.
CONNECTION ERRORS
If the clamps are reversed the Reversed Connection warning
will be displayed on the LCD with an audible beeping.
If one or both of the clamps are not in complete contact
(both the copper and silver jaw) CHECK CONNECTIONS!
will flash on the LCD.
Make sure the Infrared Printer is
properly set up.
After a test is made with the
BVA-200EX make sure the
results are displayed on the
LCD.
Point the BVA-200EX in the
direction of the Infrared Printer
(within 15 ft.)
Press the <Print> key and the
test results will be printed.
Depending upon the test made
the printer will sometimes yield
more information than the LCD.
Wait until the printer stops
printing before you press the
BVA-200EX print key again.
PRINTING TEST RESULTS
Point the BVA-200EX in the direction of the printer (in or out of the
case) with the printer’s IR receiver pointed in the direction of the BVA-
200EX. Press (Print). You should be within 15 ft. of the printer. Wait for
the screen to clear before moving the BVA-200EX. It takes a moment to
send all the test data. The BVA-200EX also operates the AC-14 printer
installed in Auto Meter’s XTC-150 and XTC-160 tester/charger or BVA-
2100 heavy duty tester/analyzer.
Connect Black
Clamp to Negative
(-) Terminal
Connect Red
Clamp to
Positive (+)
Terminal
AUTO METER
BVA 200EX
SYSTEM ANALYZER
READY TO CONNECT
>ENTER BATTERY
TEMP 70F
12.50V USE +/-.
‘Y’ TO CONTINUE
