6
23
INSPECTION
Valid automotive electrical system testing depends on all the
components being in good operating condition. In addition, the
battery MUST have sufficient charge for testing. Carefully perform the
following steps before attempting any electrical diagnosis.
VISUAL CHECK
Inspect Belts
for
cracks, glazed surface
and fraying. Tighten
loose belts.
Inspect Battery
for
terminal corrosion,
loose or broken posts,
cracks in the case,
loose hold-downs,
low electrolyte level,
moisture, and dirt
around the terminals.
Inspect Starting System.
Check starter, solenoid, and regulator for
loose connections, loose mounts and frayed or cracked wires.
Important Note:
A known defective battery must be replaced before
proceeding.
OPENING WINDOWS HYPERTERMINAL CONT.
Select file in the Hyper Terminal menu.
Select Properties.
The screen on left will appear.
Click on the Settings tab.
Make sure the “Append Lines Feed to
Incoming Line Ends” is checked.
Click ok on both screens.
Now this screen will appear.
Click on the ASCII Setup button.
