Autel MaxiBAS BT609, Manual, Page: 56 / 120

48
 To print the Diagnostics data:
1.
Tap the Diagnostics button on the Job Menu. The Print button on the diagnostics
toolbar is available throughout the Diagnostics operations.
2.
Tap Print and a drop-down menu will display.
a)
Print This Page — prints a copy of the current screen only.
b)
Print All Data
—
prints a PDF copy of all displayed data.
3.
A temporary file will be created and sent via the computer to the printer.
4.
When the file is sent, a confirmation message will display.
NOTE
Make sure the tablet and the printer are connected properly before printing.
 To submit Data Logging reports in Diagnostics:
1.
Tap the Diagnostics button from the MaxiBAS Job Menu. The Data Logging button
on the diagnostics toolbar is available throughout the Diagnostics operations.
2.
Tap the Data Logging button to display the error options. Select a specific error and
a submission form will display to let you fill in the report information.
3.
Tap the Send button in the upper-right corner of the screen to submit the report via
the Internet, and a confirmation message will display when sent successfully.
Status Information Bar
The Status Information Bar at the top of the Main Section displays the following items:
 VCI Icon
—
indicates the communication status between the tablet and the VCI device.
 Battery Icon — indicates the battery status of the vehicle .
Main Section
The Main Section varies depending on the stage of operations which shows vehicle
identification selections, the main menu, test data, messages, instructions, and other
diagnostic information.
Column 1
—
displays the system numbers.
Column 2
—
displays the scanned systems.
Column 3
—
displays the scan results.
 -!- : Indicates that the scanned system may not support the code-reading function, or
that there is a communication error between the tester and the control system.
 -?- : Indicates that the vehicle control system has been detected, but the tester cannot
access it.
 Fault | # : Indicates there is/are detected fault code(s) present; “#” indicates the
quantity of detected faults.