43
Put in fitting or removal position
This function enables you to fit in or remove the brake cable safely and easily.
It will take a few seconds to execute this command. When the job is done
successfully, the tool will display a message to confirm. If the job fails to
finish, the tool will display a message to remind user of a problem. After you
exit the diagnosis program, please repair the problem immediately.
Cable tensioning
Once the brake cable is fit in, you would use this function to adjust its tension.
It will take a few seconds to execute this command. When the job is done
successfully, the tool will display a message to confirm. If the job fails to
finish, the tool will display a message to remind user of a problem. After you
exit the diagnosis program, please repair the problem immediately.
Electric parking brake calibration
When both functions above have completed successfully, you still need to
calibrate the electric parking brake system. This function is to check if the
EPB is working correctly, which should be performed after work has been
completed on the EPB or vehicle braking system. It will remove any air gap
from the brake pads and check the EPB pressure. After you select this
function, the tool will automatically work in the following procedure.
When the job is done successfully, the tool will display a message to confirm.
If the job fails to finish, the tool will display a message to remind user of a
problem. After you exit the diagnosis program, please repair the problem
immediately.
3) In the EPB screen, use the UP/DOWN button to select Electric
parking brake replacement. The screen shows as below.
Figure 7-4
In the
Electric parking brake replacement
screen, the tool can also
perform three functions, which details could refer to the same functions
described in the
Brake cable replacement
menu above.
Electric parking brake replacement
1. Put in fitting/removal position
2. Cable tensioning
3.
Electric
parking
brake
calibration.
