30
UX-series Inverters
7.1
The following products are available to monitor UX series inverters:
Product
Port
Communicat
ion Method
Connection
To:
IOT
Capability
# Inverters
per product
Parallel
Connection
S2.WIFI-STICK
COM1
WIFI
Router
N
1
N
S2.LAN-BOX
COM2 &
COM3
WIFI OR LAN Router
N
10
Y,
Cabled (RJ45)
S2.ETHERNET-
STICK
COM1
Cabled
(RJ45)
Router
N
1
N
S2.ZWAVE-
STICK
COM1
Z-wave
Z-wave
Gateway
Y
1
N
S2.GPRS-STICK COM1
Sim Data
Cellular
network
N
1
N
S2.GPRS-BOX
COM2 &
COM3
Sim Data
Cellular
network
N
10
Y,
Cabled (RJ45)
PC or Data
Logger
COM2
Terminal
block
Local
PC or Data
Logger
N
1
N
Steps for using RJ45 connections for RS485 Communications:
1.
Use a network wire stripper to strip the insulation layer off the communication cable. Using the
standard wire sequence referenced in TIA/EIA 568B, separate the wires in the cable. Use a network
cable tool to trim the wire. Flatten the wire in the order shown in the figure below.
2.
Insert the wire into the RJ45 connector then crimp the connector with the crimping tool.
3.
Removethe cap nut from the waterproof cable glands labeled COM2 and COM3 at the bottom of the
inverter. Remove the plug from the fitting.
4.
Insert the RJ45 connector into the RJ45 port in the inverter maintenance chamber.
5.
Replace the cap nuts for COM2/3 and tighten firmly.
Please refer to related instructions of communication products for further installation instructions.Complete
monitoring setup at https://my.autarco.com/
