29 / 32
Chapter 8 Operation and Use
Never operate the lift with any person or equipment below. Never exceed the
rate lifting capacity.
Always ensure that the safety locks are engaged before any attempt is
made to work on or near the vehicle.
Never leave the lift in an elevated position unless the safeties are engaged.
If an anchor bolt becomes loose or any component of the lift is found to be
defective, Do not use the lift until repairs are made.
Do not permit the electric control panel to get wet!
8.1
Controls
Switch
The power switch can be set in two positions:
0 Position:
the electric circuit is not powered; the switch can be padlocked to prevent the use of the
lift.
1 Position:
the electric circuit is powered
Power
It shows that the electric circuit is powered
Up
When pressed, the hydraulic power unit is operated: the lift will be raised.
Lock
When pressed, the lift lowers to engage the nearest mechanical safeties.
Down
When pressed, the lowering solenoid valve is powered: the lift begins to lower under its
weight and the load lifted.
Summary of Contents for YL5000
