· Open Hood before lighting the grill to prevent an
explosion from gas build-up.
· Always inspect the gas hose and regulator
assembly before each use. If the hose is cut,
damaged, or showing signs of excessive abrasion
or wear, do not use the LP gas grill. Contact the
manufacturer, as the hose must be replaced with
an assembly specified by the manufacturer prior
to further use of the LP gas grill.
How to manually light your LP gas grill
1) Open Hood
2) Important: Make sure Control Knobs are turned “off.”
Open the LP gas cylinder valve by turning counter-
clockwise until it stops.
3) Insert a lit match through match-lighting hole
underneath the grill bowl on the right side. (See figure
below).
4) Push in and turn the right main burner control knob counter-
clockwise to the “high” position.
WARNING: If the burner fails to ignite after
following the above procedure, turn control knob to
the off position and close the valve on the LP cylinder.
Wait five minutes and repeat all of the above manual
lighting procedures. If the grill still fails to light, see
the Troubleshooting page.
5) Check to make sure that the burner is lit.
6) Light the remaining half of the burner by turning the control
knob counter-clockwise. Your grill has a crossover ignition
system that allows the burner to light each side successively.
7) If burner does not light, repeat Step 3. The burner
should light within three or four attempts.8) After ignition,
preheat the grill by turning the control knobs to “High” for 3-
5 minutes. The grill should be pre-heated before every
cooking session. The hood should be closed during
preheating.
WARNING: If the burner goes out during the cooking
cycle, turn the control knob to the “off” position and
close the valve on the LP cylinder. Wait five minutes
before attempting to relight.
Manual Lighting of the Grill
19
4. Push in right
control knob and
turn counter-
clockwise to the
“High” position.
3. Match lighting hole in right side of grill body -
Insert a lit match through the match lighting hole.
2. Turn LP cylinder handle
counter-clockwise until it stops.
1. Open hood
NOTE: Shown with right side
table removed for clarity.
