Aurora Multimedia VPH-100, Owner'S Manual

Page: 9 / 26

6
Manual Scan
Manual Scan allows you to individually add new channels into memory without running Auto Scan.
1. On the Channel
menu page, select “Manual Scan” and press the “OK”
button on the remote control. Choose the channel map you are using,
then press "OK".
(1) Off Air
For off-air additions, enter the new channel number (between 2 and 69)
on the remote control's numeric keypad. Press

to select "Scan", then
"OK" to scan for and load the channel.
(2) Cable
When adding cable channels, verify your cable type (
“STD”, “HRC” or “IRC”), then enter the new channel
number (between 2 and 125) on the remote control's numeric keypad.
“OK” button on the remote control for
scanning. Press

to select "Scan", then "OK" to scan for and load the channel.
The scanned channels will appear if the desired scanning channel has been searched successfully.
2. When finished, p
ress the “Exit” button on the remote control to leave this window.
IP Program Setting
1. On the Channel menu page,
select “IP Program” and press the “OK”
button on the remote control.
2. Select
“Add” and press “OK”, there are two sub-menus are listed.
(1) Unicast
(2) Multicast
3. Press

to highlight “Unicast”, then press the “OK” button on the
remote control, you will see the
“Channel No”, “Port” to be typed, and
press

.to select
“Add” and press “OK” to apply.
4. Press

to highlight “Multicast”, then press the “OK” button on the
remote control, you will see the
“Channel No”, “IP Adress” and “Port” to
be typed, and press

.to select
“Add” and press “OK” to apply.
5.
Press the “Exit” button on the remote control to leave this window.