Aurora Multimedia VPH-100, Owner'S Manual

Page: 8 / 26

5
SETTING UP THE TUNER
Channel Setup
Press the “Power” button on the remote control to turn the tuner on. When powering on for the first time, you will be
prompted to scan and memorize all available channels from your RF input signal. To start this process, press the
“Menu” button on remote control to display the MENU banner.
Auto Scan
Depending upon the RF input signal, you will need to scan for either off air
(antenna) or cable channels.
Off Air Scan
1.
Press the “Menu” button on the remote control to display the OSD menu.
2. Press

to highlight Channel , and p
ress the “OK” button on the remote
control. There are three sub-menus are listed.
(1) Auto Scan
(2) Manual Scan
(3) IP Program
(4) Edit
3. Press

to highlight “Auto Scan”, then press the “OK” button on the
remote control.
4. Press
 to select the “Off Air”, then press the “OK” button on the remote
control to start auto-programming.

The tuner will scan for both analog (NTSC) and digital (ATSC) off-air
content from channel 2 to 69. It takes several minutes to complete the
scanning process; the percentage bar displays the progress.
When the scan had completed
, press the “Exit” button on the remote control to leave this window. Press the “CH

” and “CH

” buttons to verify the channels found and memorized.
Cable Auto Scan
1. Follow steps 1~3 listed above to activate the Auto Scan function for cable signals.
2. Press
 to select “Cable” and press “OK”. Use  to select “STD”, “HRC” or “IRC”, then press the “OK”
button on the TV or remote control.
Note : STD, HRC, and IRC identify various types of cable TV systems. Contact your local cable company for the
type of cable system that exists in your particular area.

The tuner scans for all QAM digital and NTSC analog signals from channel 2 to 125. It takes about five
minutes to complete the whole scanning process; the percentage bar displays the progress.
When the scan has
completed, press the “Exit” button on the remote control to leave this window.
Pr
ess the “CH  ” and “CH  ” buttons to verify the channels found and memorized.