The technical characteristics can change without notice. AUR°EL S.p.A doesn’t assume the respons
AUR°EL S.p.A.
Via Foro dei Tigli, 4 - 47015 Modigliana (FC)
Tel.: +390546941124 – Fax: +390546941660
http://www.aurel.it
Note 1
: HS = High Sensitivity , NS = Normal Sensitivity.
Note 2
: Data rate “on air”. In case of more than 4 consecutive identical symbols, bit stuffing can reduce this
data rate from 100% down to 80% of this value.
Note 3
: See Table 10 for more detai
7.
Functional modes
This section describes the operational modes of the RTX
in Figure 3, and each mode is described below. The SPI interface is
loading and running the corresponding subroutine. Most transitions are immediate, shorter than t
transactions, except for those marked in the figure and listed in T
Figure
Notes:
1.
See SPI Operation chapter.
The technical characteristics can change without notice. AUR°EL S.p.A doesn’t assume the responsibility to the damages caused by an improper use of the
47015 Modigliana (FC) – ITALY
Fax: +390546941660
Sensitivity , NS = Normal Sensitivity.
In case of more than 4 consecutive identical symbols, bit stuffing can reduce this
data rate from 100% down to 80% of this value.
for more detailed power amplifier settings
.
operational modes of the RTX-24EM module. An example state diagram is give
described below. The SPI interface is used to set or change the mode by
running the corresponding subroutine. Most transitions are immediate, shorter than t
those marked in the figure and listed in Table 5: Timing Characteristics.
Figure 1: RTX-24EM Functional Overview
RTX-24EM
User guide
bility to the damages caused by an improper use of the device.
12/11/2019 - Rev. B
Fax: +390546941660 Page 11
In case of more than 4 consecutive identical symbols, bit stuffing can reduce this
. An example state diagram is given
ed to set or change the mode by
running the corresponding subroutine. Most transitions are immediate, shorter than the SPI
: Timing Characteristics.
