Auerswald COMmander Basic.2, Installation And Commissioning Instructions

Page: 78 / 84

Service and Maintenance
78
Saving the Firmware File in the PBX (Manual Firmware Update)
Requirements
– Opened configuration manager (with an existing con-
nection to the PBX web server)
– The firmware file saved on the hard drive
Note: You can download the firmware file from the
support pages at the Auerswald web site (Internet
address: www.auerswald.de).
Important: When performing a firmware update, the
PBX should be in the idle state.
Steps to Take
1.
Open the page Administration Firmware update/
restart.
2.
Click Browse and select the firmware file.
3.
Click Store in the PBX.
If you have the status bar enabled in your
browser, for example, in Microsoft Internet
Explorer, the progress is displayed.
As soon as the firmware file has been saved in
the PBX, you will receive a message.
Note: The new firmware is currently not yet enabled.
The old firmware is retained for the moment.
Further Steps
쑱
Restart the PBX in order to enable the new firmware.
See also
Page 76 .
쑱
In order to use new features after a firmware update,
you normally need a new version of the operating
manual and the configuration manual. Both are
available per download from the support pages at the
Auerswald web site (Internet address:
www.auerswald.de).
Restoring Firmware Using the PC
Requirements
– Opened configuration manager (with an existing con-
nection to the PBX web server)
Steps to Take
1.
Open the page Administration Firmware update/
restart.
2.
Click Restore firmware.
3.
Click OK.
The “Status” LED and the “Power” LED light up in
red and orange for several seconds/minutes
during the restart. See also the table on
Page 71 .
If both LEDs light up in green again, the restart is
complete and the PBX is ready for operation.
Note: If the “Power” LED remains continuously lit in
red, an error has occurred. Please contact your
dealer or the manufacturer directly.
Restoring Firmware at the Touch of a Button
Requirements
– Open casing
Warning: Improper handling of the device can result
in life-threatening electrical shock.
씮
Only a skilled electrician may open the casing and
perform installation work within an open casing or
service work using the buttons inside the casing.
If necessary, commission an authorised dealer to
perform this work.
Note: The buttons and LEDs are easily visible and
accessible on the front panel of the 19" casing
variants.
Note: This function requires performing the steps
rapidly. Make sure you are comfortable with the
procedure before you begin.
Steps to Take
1.
Press the “Reset” button. See Fig. 65 .
2.
Within the space of 2 seconds, push the “Alternate”
button and hold it.
The “Status” LED starts to quickly blink in orange.
After a few seconds, the blinking of the “Status”
LED will slow down.
3.
Let go of the “Alternate” button.