L.E.D.
DRILL A 1/4" DIAMETER HOLE
TOGGLE SWITCH
HEX NUT
SPLIT LOCKWASHER
DRILL A 9/32" DIAMETER HOLE
SHEET METAL
SCREWS
RELAY
MOUNT INSIDE
PASSENGER'S
COMPARTMENT
RELAY
Page 2
3. Mounting The Dash L.E.D. Indicator
Select an area on the dashboard or center console that will provide the
most visibility from all angles outside the vehicle ( driver’s window,
passenger’s window, rear window, etc. ).
IMPORTANT !
Make sure there is adequate room for the body of the
L.E.D.behindthepanelintheselectedlocation.Youshouldalsobesure
that the drill will not pierce any wires, or damage other components after
passing through the panel. It is always best to remove the panel from
the vehicle before drilling the hole.
To mount the L.E.D.;
A.
Drill a 1/4" diameter hole at the selected mounting location.
B.
Pass the L.E.D. wires through the hole from the front of the panel,
and press the body of the L.E.D. into the hole until fully seated.
4. Mounting the Valet Toggle Switch
Select a flat area on the lower dash lip, where the switch is readily
accessible to the driver, but will not be accidentally bumped. Other
alternate locations are on the driver’s side kick panel, or the side of the
lower steering column cover.
Since this is a “ protected “ ( will only operate when the key is in the
ignition ) bypass switch, it does not have to be concealed, however
concealing the switch is always recommended, as this provides an even
higher level of security to the vehicle.
IMPORTANT !
Make sure there is adequate room behind the panel for
the body of the switch in the selected location. You should also be sure
that the drill will not pierce any wires, or damage other components after
passing through the panel. It is always best to remove the panel from the
vehicle before drilling the hole.
To mount the valet bypass switch;
A.
Drill a 9/32 “ diameter hole in the selected switch location.
B.
Passtheswitchthroughtheholefrombehindthepanel,andsecure
from the front using the split lockwasher and hex nut provided.
5. Mounting the Relay
The relay can be mounted in the engine compartment, but it is best to
mount it in the passenger’s compartment, where it will not be exposed
to the environment. If the relay will be used to disable the vehicle’s
starter, mount the relay close to the wires from the ignition switch. If the
relay will be used to flash the vehicle’s parking lamps, mount the relay
near the front parking light cluster.
To mount the relay;
A.
Screw the relay to the mounting surface, using a sheet metal screw
through the hole in the relay mounting tab.
B.
Secure the relay to an existing wire harness or other component
using cable ties.
WIRE TIE TO EXISTING
HARNESS IN VEHICLE
