16
Connectors and control units
1
Control pushbutton
Use this button to either switch between the
setups or initiate a reset of the device
2
Status LED
This LED indicates the operating mode of the
DSP and which setup has been chosen
3
USB Input
Connects the HELIX P SIX DSP to your PC
4
Control Input
Multifunction interface for e.g. an optional re-
mote control or other HELIX accessory
5
Optical Input
Optical input for digital stereo signals (SPDIF
format)
6
Input Sensitivity
Controller for adjusting the input sensitivity of
the low- and highlevel inputs for the individu
-
al stereo signals
7
Line Input
RCA inputs for connecting pre-amplifier sig
-
nals
8
Highlevel Input
Highlevel speaker inputs for connecting a
factory radio or an aftermarket radio without
pre-amp / line outputs
9
Output Channels A - D
Speaker outputs A - D for connecting spea-
ker systems. The channels A and B may not
be loaded with more than 4 Ohms, all other
channels are 2 Ohms stable
10
Clipping LED
This LED lights up red if one of the analog
inputs is overdriven
11
Fuse
This LED lights up red if a fuse is faulty in the
device
12
GND
Connector for the ground cable (negative
terminal of the battery or metal body of the
vehicle)
13
REM
Connector for the remote cable
14
+12 V
Connector for the +12 V power cable to the
positive terminal of the battery
15
Line Output
Line outputs for connecting external ampli
-
fiers. Make sure that the „Remote Output” is
used to turn on these devices
16
Rem Out
The remote output has to be used to turn on/
off external amplifiers that are connected to
the RCA line outputs. Both connections are
internally wired in parallel
17
Output Channels E - F
Speaker outputs E and F for connecting
speaker systems. These channels are
2 Ohms stable
9
10 11
12 13
14
15 16
17
1
4
3
2
5
6
7
8
