- Commissioning -
33
3 Commissioning
3.1 General
Information
NOTE! Before commissioning, it is essential that you read the General Information
at the beginning of this manual.
3.2 Check contents of pack
The following items are supplied
one telephone base
one telephone receiver
one telephone connecting cable
one spiral cable
one desk support
one instruction manual
one mains power supply
3.3 Fitting the batteries
Before connecting your new telephone to the telephone network, the batteries
should be installed. Please always use four new alkaline batteries, type AAA/LR03
1.5 V only. The batteries are used for preventing loss of data if there should be a
mains power failure. Before installing or changing the batteries make sure that the
telephone is not connected to the telephone network.
1. The battery compartment is to be found on the underside of your telephone.
2. Open the battery compartment with a small screwdriver or a pointed object.
3. Insert the batteries. In doing so, ensure that the polarity is correct.
4. Close the battery compartment.
The batteries should be changed when this symbol
appears in the
display. All four batteries must then be replaced
3.4 Connecting the receiver
After unpacking your telephone, you must first connect the telephone receiver to
the base unit. First take the short end of the spiral cable and plug it into the
socket at the bottom of the receiver. Turn the telephone over and plug the long
end into the socket marked HANDSET. Feed the cable through the cable channel
to the outside.
3.5 Connecting the telephone
Connect the telephone cable supplied to the telephone socket and the telephone
jack LINE on the underside of the telephone. Then feed the cable out of the
telephone housing either upwards or downwards through the cable guide. Clip the
cable firmly in the cable channel.
The telephone works using the tone dialling system.
