Hardware Installation Manual
5. Initial Configuration
Version 7.0
31
Mediant 9000 SBC
5
Initial Configuration
5.1
Reconfiguring Default IP Address to Match
Customer Network Settings
The Mediant 9000 is supplied with software preinstalled. By default, the device is assigned
with a default IP address that will most likely be inaccessible from the customer's network.
Table
5-1: Default IP Address
Parameter
Value
IP Address
192.168.0.1
Subnet Mask
255.255.255.0
Reconfigure the IP address in order to connect to the Mediant 9000's Web-based
management tool (hereafter referred to as 'Web interface').
To reconfigure the IP address using CLI:
1.
Use the VGA monitor and keyboard to connect to the CLI management interface.
2.
At the prompt, type the username (default is
Admin
- case sensitive), and then press
ENTER:
Username:
Admin
3.
At the prompt, type the password (default is
Admin
- case sensitive), and then press
ENTER:
Password:
Admin
Figure
5-1: CLI Management Interface
4.
At the prompt, type
enable
and press ENTER:
>
enable
5.
At the prompt, type the password again and press ENTER:
Password:
Admin
6.
At the prompt, type the following commands to access the network interface
configuration:
#
configure voip
(config-voip)#
interface network-if 0
(network-if-0)#
